KST SERVO PROGRAMMER #1

The KST Servo Programming Tool #1 is used for programming KST V6.0 and V8.0 servos without the need for a PC or other computer.

This tool has a simple press-button interface that allows the servo mid point and end points to be set. It also allows the direction of rotation to be reversed.

Operating Instructions

1. Connect to the power supply suitable for your servo (*IMPORTANT!!*).
2. Tool Card #1 will beep twice, and GREEN LED will start blinking.
3. Connect the V6.0 & V8.0 servo, 1500μs RED LED will up.
4. Press the middle +/- button to set the mid-point, then press ENTER once to save or twice to save & exit.
5. Press each side +/- button to set the left and right end-point, then press ENTER to save & exit. Tool Card #1 will return to GREEN LED blinking stand-by.

*CW/CCW setting only works in end-point adjust mode.
**RESET button resets Tool Card #1 only, it will not reset the servo.