HS-7955TG Digital High Speed, 2nd
generation(G2) programmable circuitries
For Airplane, Glider, Heli, Car, Boat, larger aircraft or monster trucks
Hitec's best servo just got better.
Based on the powerhouse HS-5955TG servo the HS-7955TG has the added benefit of
our G2 second generation programmable digital circuit.
This new circuit has twice the resolution of our original circuit while adding
programmable overload protection.
The HS-7955TG has been designed for the most demanding hobby applications
including the largest aircraft and monster trucks.
Featuring a titanic 333oz./in. of torque at 6.0 volts, all this power is
harnessed by incorporating the industries first Titanium gears for incredible
wear resistance and two strong hardened steel gear pins and axial brass bushing
in the servo case.
Detailed Specifications
Motor Type: Coreless
Bearing Type: Dual Ball Bearing
Speed: 0.19 / 0.15 sec @ 60 deg. (4.8v/6v)
Torque: 250 / 333 oz.in 18 / 24 kg.cm (4.8v/6v)
Size: 1.57" x 0.78" x 1.45" 40.00 x 20.00 x 37.00mm
Weight: 2.29oz 65.00g
Overload Protection:
This funtion is to protact the servo overload condition, Once the servo
is force to overload condition for certain time,
the motor out put will decreased to user setting level, please note this setting
is deactivated (OFF) by factory setting, .
Resolution modes setting:
There are two resolution modes (High and Normal) in HS7xxx servo setting,
factory default is set at "HIGH" resolution,
and servo travel will be 120 degree, If the user need to widen the servo travel,
user may sellect the "Normal" resolution,
so the servo will be travel into 180 degree by using the HFP-20 servo
programmer to funtion the setting.
Detailed
Feature Descriptions:
G2 Digital Circuit
Coreless Motor
Dual Ball Bearing Supported Output Shaft
Titanium Gear Train (MK first gear)
Programable Features Include:
Dead Band Width
Direction of Rotation
Speed of Rotation (slower)
End Points
Neutral Points
Fail Safe On/Off
Fail Safe Point
Resolution* (default is high resolution)
Overload Protection* (default is off)
*these features are only programable with the HFP-20 field programmer
HFP-20 servo programmer link here.